Skip to content
Tidy

Mould on the bathroom ceiling: how to get rid of it, and keep it gone

Clean it off, fix why it grew, then repaint with a paint made for wet rooms. NSW Health's advice is to clean mouldy surfaces with diluted vinegar, or diluted bleach if that doesn't shift it, and to treat the cause or it will come back. On a bathroom ceiling the cause is nearly always steam with nowhere to go. Painting over mould without doing the first two steps just hides it for a few months.

Last checked

Why does mould grow on the bathroom ceiling?

Because the ceiling is where the steam ends up. Hot, wet air from a shower rises, hits the cooler ceiling and condenses into a film of water, and NSW Health notes that mould grows indoors in wet or moist areas that lack adequate ventilation. Every shower re-wets it, so the black spots appear in the corners and above the shower first.

The Illawarra makes it harder. Coastal air is humid much of the year, winters under the escarpment are cool and damp, and a lot of the region's older fibro, weatherboard and brick-veneer houses have small bathrooms with a little window or a ceiling fan that was installed decades ago. A bathroom that dries out in an hour inland can stay damp all afternoon in Thirroul or Kiama.

Check for the less obvious causes too. A patch of mould with a brown water stain round it, or one that sits away from the shower, can be a roof leak, a failed flashing or a leaking pipe above the ceiling. That needs fixing at the source before any paint goes on.

How do you clean mould off a bathroom ceiling?

With a mild detergent, or vinegar diluted four parts vinegar to one part water, for routine mould. NSW Health says that if the mould won't come off, use a diluted bleach solution of 250 ml of bleach in 4 litres of water, wear PVC or nitrile gloves and safety glasses, keep the room well ventilated, and dry the surface completely afterwards.

If the mould comes back within weeks of cleaning, or the plasterboard is soft, sagging or stained right through, the board itself is affected and the ceiling needs repair or replacement, not just paint. NSW Health also notes that mould can be present in ceiling cavities where you can't see it; an occupational hygienist can test for it if you can't find the source.

  • Open the window and run the fan before you start, and keep them going.
  • Wear gloves and eye protection; spray on a ceiling drips back at you.
  • Wipe rather than scrub hard. Painted plasterboard marks easily, and you want the mould off, not the paint.
  • Dry the ceiling fully afterwards. Mould on a wet surface comes straight back.
  • If the house was built before 1990 and the ceiling is textured, don't sand or scrape it until it has been tested for asbestos. If it was built before 1970, assume old paint may contain lead and follow the NSW LeadSmart rules.

How do you stop bathroom mould coming back?

Get the moisture out. NSW Health's list starts with ventilation: turn on exhaust fans when showering, and open windows when the weather allows. Run the fan for the whole shower and a good while after, leave the door open when you're done, and squeegee or towel the walls and screen so less water evaporates into the room.

Look at the fan itself. An old ceiling fan that is noisy but barely moves air, or one that blows into the roof space instead of through a duct to the outside, moves the problem rather than solving it: the wet air condenses on the timber and the back of the plasterboard instead. Hold a sheet of toilet paper under the grille; if the fan can't hold it, it isn't doing much. Upgrading to a ducted fan on a run-on timer is an electrician's job, and it usually does more for the ceiling than any paint.

A window helps only if it's open. In winter nobody leaves one open after a shower, which is why the fan matters more than the window in most Illawarra bathrooms.

What is the best paint for a bathroom ceiling?

A paint made for wet rooms, with a mould inhibitor in it, over a sealer or stain-blocking primer if the old ceiling is stained. The big makers all sell one: Dulux's Wash&Wear +PLUS Kitchen&Bathroom is a low sheen for rooms with high humidity or condensation, Haymes's Ultra Premium Kitchen & Bathroom carries a 10-year mould and mildew guarantee, and Taubmans' Easycoat Ceiling paint is a flat finish with what it calls Bacteria Shield technology.

Two things matter more than the brand. First, sheen: a low-sheen or kitchen-and-bathroom finish sheds moisture and can be wiped down, where a cheap flat ceiling white soaks it up. Second, the system: an anti-mould topcoat over a mouldy, damp or unsealed ceiling fails just as fast as any other paint. The order is clean, dry, prime any stains, then two coats.

Anti-mould paint slows mould down; it doesn't stop it in a room that's wet all day. Read the guarantee conditions too. Haymes's and other makers' guarantees depend on the paint being applied as directed, and a ceiling that's dripping every morning is outside what any of them promise.

How much does it cost to repaint a mouldy bathroom ceiling in Wollongong?

The Quote Yard puts ceiling painting in Newcastle and Wollongong at about $20 to $34 per square metre in 2026, and a water-stained ceiling that needs a sealer treatment at $25 to $45 per square metre across NSW. A bathroom ceiling is a small area, so on a job this size the preparation, the drying time between coats and a minimum call-out charge make up most of the price.

It is usually worth doing the bathroom ceiling alongside other rooms rather than on its own, because the set-up cost is shared. Our ceiling painting cost page has the full breakdown, and the calculator prices a whole interior.

Ceiling jobTypical rate (NSW, 2026)
Standard flat ceiling, Newcastle and Wollongong$20–$34 per m²
Water-stained ceiling requiring sealer treatment$25–$45 per m²
Cornice painting$6–$14 per linear metre
Asbestos test on a textured pre-1990 ceiling$50–$150 per sample

The Quote Yard, ceiling painting cost NSW (2026). Regional NSW sits below Sydney.

Is mould on the bathroom ceiling dangerous?

For most people, no. NSW Health says most people will not have health problems from contact with mould, but that people with asthma, allergies or other breathing conditions may be more sensitive to it, and people with weakened immune systems are more at risk. If someone in the house has symptoms, see a doctor. Either way, it's worth removing as soon as it appears.

If you rent, NSW Health's advice is to raise mould with the owner or agent if it keeps growing after you've ventilated properly. NSW Fair Trading covers tenants' rights on repairs.

Questions people ask

Can you paint over mould on a bathroom ceiling?

No. Kill and clean it first (diluted vinegar, or diluted bleach per NSW Health), let the ceiling dry fully, seal any stains, then paint. Paint over live mould traps it and it comes back through the new coat.

What kills mould on a bathroom ceiling?

NSW Health recommends a mild detergent or vinegar diluted four parts to one part water for routine mould, and a diluted bleach solution of 250 ml of bleach in 4 litres of water if that doesn't work, with gloves, eye protection and good ventilation.

Does anti-mould paint work?

It slows mould growth on the paint surface, and the kitchen-and-bathroom ranges from Dulux, Haymes and Taubmans are made for it. It doesn't fix a room that stays wet, so sort the fan and ventilation first.

Why does mould keep coming back on my bathroom ceiling?

Because the room is still getting wet and not drying out: an exhaust fan that is too weak, not run long enough, or venting into the roof space, or a hidden leak above the ceiling. Fix the moisture and the mould stops.

How much does it cost to paint a bathroom ceiling in Wollongong?

Ceiling painting in Wollongong runs about $20 to $34 per square metre in 2026 (The Quote Yard), and $25 to $45 per square metre where stains need a sealer. On a small bathroom the prep and minimum charge make up most of the bill.